One Day One Knife

The course goes from 8am until 5:30pm in one very packed day. 

The stock removal process makes knives from grinding them out of steel blanks. No forging or hammering is used in the method. It is a great way to get into knifemaking as it needs much less equipment.

After an overview of the day, we select a design for the knife from a number of templates. The design is traced onto the carbon steel blank then profiled using a the grinder and bandsaw. Bevels are ground in, with the edge ground to about 1mm thick. Then holes in the tang are drilled and tapped to attach the scales.

Handle scales are selected from a range of timber then milled flat, drilled and profiled. 

The blade is hardened and tempered before finally grinding the edge down to less than .3mm. Higher grits are used to get a good working finish on the blade. There is an option to acid etch and tumble finish the blade.

The handle scales are then shaped for a comfortable fit and then finished before being screwed onto the blade.

A very busy day where you create you own knife from scratch.

Cost includes: Tuition, insurance, materials, use of tools, workshop consumables, safety gear, morning and afternoon tea.
Need to bring: Lunch, appropriate clothing and covered footwear


Start Time 8:00 am
Sun 29-10-2023
Finish Time 5:30 pm
Sun 29-10-2023
Capacity 5
Registered 5
Available 0
Price $500
Location Cuppacumbalong

Venue Information - Cuppacumbalong

Cuppacumbalong Homestead is located at 21 Naas Road in Tharwa ACT. Park onsite at bottom of the driveway. Fridge and microwave available for storing and reheating lunches.

Sorry, the event is now full and we could not accept more registration

Location Map

Hear about opportunities before everyone else, subscribe to our newsletter

Get early access to amazing experiences. We will never spam you, and you can unsubscribe at any time.